Known Issues

From Sketching with Hardware at LMU Wiki
Jump to navigation Jump to search

In our work and during the course a number of issues have come up ... and for some of them, there are also solutions.

PWM Output (for Servos)

Re-execution (basically executing a script more than once, without rebooting in between) may not work. PWM output will not switch off.

the workaround is to always deinit the PWM before using it, e.g.

1 servoPin = Pin(26, Pin.OUT)
2 pwm = PWM(servoPin, freq=50)
3 pwm.deinit()
4 pwm = PWM(servoPin, freq=50)

Servos

Servos and Power

Servos and motors are power-hungry and many of them will also require a higher voltage. A sign of the servo not having enough power is, that it does not move smoothly or that it only jitters.

Servos have in general 3 connections: GND, VCC/+, and PWM (the control pin).

A typical way to connect it is to connect PWM to the ESP32/ESP8266 (and to a PWM output pin). The GND is also connected to the ESP. VCC/+ is connected to the power supply, in the most simple case the 5V Pin of the ESP32/ESP3266 - this is connected to the 5V of the USB Port (and limited to 500mA with a fuse).

If you need more power you can use an external power supply, here it is important to connect 0V/-/GND to GND of the ESP and the VCC/+ of the supply to the VCC/+ of the servo.

Black Servo ES08MA II

The power (current and voltage) of many USB Ports connected to the ESP32/ESP8266 is not enough for the Servo ES08MA. It many cases it will not work.

Es08maII-servo.PNG

Workaround: use the servo SG90.

ESP32 lableing

It seems there is a false marking on the additional labels that come in the box. On the left side the additional label says 5V - but the associated pin is actually 3.3V

ESP32labels.jpg


RGB LEDs

There are two types of RGB LEDs.

There is the standard RGB LEDs (this is included in the LMUBox) - which is basically only 3 LEDs in parallel in one housing, see: https://www.sketching-with-hardware.org/wiki/RGB_LED

There are also "intelligent" RGB LEDs and the are controlled like the NeoPixel Ring (or the WS2812 chip): https://www.sketching-with-hardware.org/wiki/LED_Ring_NeoPixel