Editing Push button

= Description =
With a button we can select which of the two sides are connected to the middle. It is similar to a [[switch]] but it only stays in the state as long as it is pressed.

[[File:Button02.PNG|x200px]]

= How to connect it electrically =
This is the most simple way of connecting a button. if the button is not pressed (open) there is no signal at the pin. Hence here we should use an internal pullup resistor.

[[File:Button01.PNG|300px]]


This is the connection of a button with a pullup resistor. If the button is not pressed, 3.3V are connected to the pin via the 10 KOhm resistor (reads 1). if it is pressed it is connected to GND (reads 0).

[[File:Pullup02.PNG|300px]]

= How to control it in MicroPython =

== Simple digital read on pin 26 with internal Pull-up
<syntaxhighlight lang="python" line='line'>
from machine import Pin
in26 = Pin(26, Pin.IN, Pin.PULL_UP)
print(in26.value())
</syntaxhighlight>

== Simple digital read on pin 26 ==
<syntaxhighlight lang="python" line='line'>
from machine import Pin
in26 = Pin(26, Pin.IN)
print(in26.value())
</syntaxhighlight>

= Related Tutorial Videos =
Digital Input

<youtube>va1beT6sxLs</youtube>