Editing Tasks SoSe2020
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 10: | Line 10: | ||
* [[Tutorial Analog IN]] | * [[Tutorial Analog IN]] | ||
* [[Tutorial Display]] | * [[Tutorial Display]] | ||
− | |||
− | |||
Line 23: | Line 21: | ||
# Getting the ESP32 Hardware running; Blink internal LED, Print to serial line | # Getting the ESP32 Hardware running; Blink internal LED, Print to serial line | ||
# Output: LEDs with resistors, RGB LED, PWM | # Output: LEDs with resistors, RGB LED, PWM | ||
− | # Input: buttons, | + | # Input: buttons, Poti, Light dependent resistor |
# Mini System: connect a sensor and print to Display | # Mini System: connect a sensor and print to Display | ||
# Mini System: connecting a servo to a poti or slider | # Mini System: connecting a servo to a poti or slider | ||
Line 29: | Line 27: | ||
== Group Task == | == Group Task == | ||
− | + | Networked Mini System | |
− | |||
− | |||
* generating sound on one ESP based on sensor values measured on another ESP in another location | * generating sound on one ESP based on sensor values measured on another ESP in another location | ||
* the system should be symmetric, both sides have a sensor, a piezo speaker, and a switch | * the system should be symmetric, both sides have a sensor, a piezo speaker, and a switch | ||
Line 47: | Line 43: | ||
Be prepared for a discussion: | Be prepared for a discussion: | ||
− | * on the technical feasibility | + | * on the technical on the feasibility |
* about your time plan | * about your time plan | ||
* things you need to build your hardware sketch | * things you need to build your hardware sketch |